Vacuum

QUICK DISCONNECT
The quick disconnects are make of high carbon steel that has been plated to halt oxidation. Each one has high temperature Viton )-rings that withstand continuous use up to 500 F. The internal springs and fittings are corrosion resistant and of the highest quality materials available. Part # 95024
Qty: Our Price:$26.83

RELEASE FILM PERF 10 YDS
A perforate plastic fims may be used in conjuction with the release fabric. This film helps hold the resin in the laminate when high vacuum pressure is unsed with slow curing resin systems or thin laminates. Size: 10 yds Part # 95006
Qty: Our Price:$18.50

RELEASE FILM PERF 25 YDS
A perforated plastic film may be used in conjunction with the release fabric. This film helps hold the resin in the laminate when high vacuum pressure is used with slow curing resin systems or thin laminates. Perforated films are available in a variety of hole sizes and patterns depending on the clamping pressure and the resin's open time and viscosity, Size: 25 yds Part # 95007
Qty: Our Price:$46.25

RELEASE FILM PERF ROLL
A variety of release materials are produced specifically for vacuum bagging operation. They may be know as release fabric, peel ply or release film. May are desined for use a high teperatures or to control the amount of resin that can pass through them. Size: Roll 1000' Part # 95005
Qty: Our Price:$618.30

SEALANT TAPE 375F
This tape will seal the bag to aluminum, steel, nickel, and graphite tool surfaces yet strips easily. Use to plug leaks and tears in the bag that develop during cure. Part # 95020
Qty: Our Price:$11.17

SEALANT TAPE CASE
Sealant (mastic) is used to provide a continuous airtight seal between the bag and the mold around the perimeter of the mold. The tape may also be used to seal the point where the manifold enters the bag and to repair leaks in the bag or plumbing. Generally, the better the airtight seal between the mold and bag material, the smaller the pump you'll need. Poor seals, or material which allows air leaks, will require a larger capacity pump to maintain satisfactory vacuum pressure. Size: Case/20 Part # 95019
Qty: Our Price:$223.40

VACUUM VALVE 400F
Vac Valve 400 is a twist valve that mechanically seals before vacuum is drawn. The valve provides a chamber that helps prevent seal off. The valve has a threaded core allowing the operator to turn until completly tight against the seal. Made from aluminum and the seal gasket is fully cured silicone rubber. Part # 95023
Qty: Our Price:$35.06