added to unwaxed polyester and vinyl ester resins and gelcoats to
achieve a tack-free surface suitable for sanding. Commonly used in
final coat, 3% by volume.
are achieved when used
with PVA. We recommend that new moulds are coated with four layers
before use. Apply two coats of wax, buff off the excess, and allow
to stand for an hour before applying the last two coats to give
solvents extra time to evaporate so a tougher wax barrier develops.
Available in Honey Wax 14oz or Mirror Glaze 11oz.
polyester, casting, tooling, ISO resins as well as gelcoats.
Catalyst Hardener MEK 50%
Available in 28ml, 56ml, 250ml, 8lb (50%), 7lb (30%)
is a very powerful solvent which will clean fibreglass boats,
act as a solvent for epoxy and polyester resin to clean tools and
equipment, remove most old adhesives and dissolve most plastics such
as polystyrene, polyesters, cellulose acetates, ABS.
2 Part Foam
used for flotation and lightweight (R5 to R7) insulation - 2
lb density. 1 lb. of Part A and 1 lb. of Part B mixed foam will fill
one cubic foot space - 2 lb. Per cubic foot density.
is the recommended and accepted thinner for polyester resins and
gelcoats. Most gelcoats can be thinned 2-5% to make them suitable
for ordinary spray equipment or other special purposes.
PVA should be used to aid
in the release of parts from a mould.
above chemicals are available in 250ml, 1L, 3.78L, & 20L